Dexter grease fitting, 1/4"-28, for 0.230-0.235" hole (pack of 2)
Pick suspension parts by spring width and type, axle spacing (center of axle to center of axle), number of axles and axle rating, then measure the old equalizer (hole to hole) and hanger height. A kit made for another spacing moves the axles and the tires can hit. Weld-on hangers must be welded square and in line by someone qualified. Dexter 059-547-00: torque every flanged locknut (spring eye, equalizer and shackle bolts) to 30-50 ft-lb with the nut seated against the bolt shoulder. Press the bronze bushings into the spring eyes first (piloted punch or a 9/16" bolt, never strike the bushing). Drive the wet bolts with a tube over the grease fitting, not an impact wrench. Grease the fittings with NLGI 2 lithium complex grease until it shows at the bushing ends, every 3,000 miles for best results. Check that lifting one axle lowers the other. Static bump clearance (axle to frame, loaded): over 2-1/2" use a bump stop so the springs aren't overstressed; under 1-1/2" can limit suspension travel and damage the frame or axles on rough roads; tire clearance must always be more than bump clearance.
Specs
- thread
- 1/4-28
Interchangeable part numbers
| Maker | Part number | Basis |
|---|---|---|
| Dexter | K71-292-00 | Maker's own listing |
| Dexter | 061-007-00 | Maker's own listing |
Where to buy
No seller prices on file yet.
Prices are what each seller's page showed on the date listed and are re-checked after 29 days. TrailerApp may earn a commission from some sellers. Confirm against the tag on your axle or hub before ordering.
Not sure this is your part? Ask Trailer AI with your axle rating or the number on the old part.